Projects / 06 · Collection

Computer-Aided Design & Engineering Drawings

Mechanical CAD models, assemblies and engineering drawings. I created the 3D models and 2D drawings for every entry here. The robotic arm is my own design; the others are modelling and drafting work.

IN THIS COLLECTION

FEATURED DESIGN · 01

Robotic Arm with Geared Gripper

My own design, developed from the general layout of existing robotic arms: a five-section arm on a ribbed base, finished with a gripper whose jaws are driven by a pair of meshing gears. I modelled every part, assembled the mechanism in CAD and drew the complete set.

YEAR
2023
ROLE
Design, CAD modelling, drafting
DRAWINGS
17 sheets, A4
STATUS
CAD and drawings, not built
Robotic Arm AssemblyScale 1:5
Gripper AssemblyScale 1:2

PART DRAWINGS · 15 SHEETS · SELECT TO ENLARGE

BaseScale 1:10
First ArmScale 1:5
Second ArmScale 1:5
Third ArmScale 1:5
Fourth ArmScale 1:5
Fifth ArmScale 1:3
WristScale 1:2
Wrist PinScale 2:1
Gripper BaseScale 1:2
ClawScale 1:2
Gear 2Scale 1:2
Gear Revisi 3Scale 1:2
SupportScale 1:2
33 mm PinScale 2:1
42 mm PinScale 2:1

CAD & DRAFTING · 02

Grooved Wheel & Bracket Assembly

A grooved wheel running on a bearing, held in a folded bracket by a bolt and nut. I modelled the seven parts, assembled them in CAD and produced the drawing set.

YEAR
2023
ROLE
CAD modelling, assembly, drafting
DRAWINGS
8 sheets, A4
AssemblyScale 1:2
FrameScale 1:1
WheelScale 1:1
BearingScale 1:1
Ring InnerScale 1:1
Ring OuterScale 1:1
BoltScale 1:1
NutScale 1:1

CAD & DRAFTING · 03

Screw Clamp Assembly

A screw clamp with a C-shaped stand, a separate jaw block and a threaded screw ending in a pad. I built the five part models and the assembly in CAD, then drew the full set.

YEAR
2023
ROLE
CAD modelling, assembly, drafting
DRAWINGS
6 sheets, A4
AssemblyScale 1:2
StandScale 1:2
BodyScale 1:1
Screw RodScale 1:1
Screw BaseScale 2:1
PinScale 2:1

CAD & DRAFTING · 04

Slider Mechanism

A small slider mechanism, similar to a Scotch yoke, where a wheel’s offset pin sits in the slot of a sliding bar. I modelled the five parts, assembled them in CAD and drew each one.

YEAR
2023
ROLE
CAD modelling, assembly, drafting
DRAWINGS
6 sheets, A4
AssemblyScale 1:1
Base MountingScale 1:1
SliderScale 1:1
Free WheelScale 1:1
BushingScale 1:1
Thumb ScrewScale 2:1

CAD & DRAFTING · 05

Hinged Box Assembly

An open-fronted box with a door on a three-part pin hinge. I modelled the box, door and hinge parts, assembled them in CAD and produced the drawings.

YEAR
2023
ROLE
CAD modelling, assembly, drafting
DRAWINGS
6 sheets, A4
AssemblyScale 1:10
BoxScale 1:10
DoorScale 1:5
Inner HingeScale 1:2
Part HingeScale 1:2
Slot HingeScale 1:1